| INSTALLATION FOR SPECIAL
CONDITIONS |
| Photo 15 |
 |
 |
Photo 16 |
| Photo 17 |
 |
 |
Photo 18 |
CONDITION 1
When space between propeller and strut is too narrow
to mount cutter:
| OPTION 1: |
Removal of a ring from strut boss the width necessary to allow
enough space for mounting cutter, including any end play. Procedure is
as follows:
a) Scribe a ring around strut allowing space for cutter and end
play (Photos #15, #16 and #17).
b) Cut strut through bearings stopping at rubber; using a knife,
cut through rubber and remove ring. Make a side cut before completing
the cut when the propeller has not been removed (Photo #18).
c) Remove the ring, and follow installation instructions..
|
| OPTION 2: |
Install SPURS® Spacer between transmission and shaft
flange. A 1" spacer will lengthen shaft allowing an additional 1" for
cutter to be installed. (Photo #19). |
SPURS® Spacers are available through Spurs
Marine:
Contact us for sizing. We will need the Make and Model # of your
transmission.
SPURS" Spacers are solid steel, machined parallel within .001 and are
electroless nickel plated.
| Photo 19 |
 |
 |
Photo 20 |
CONDITION 2
Too much space between propeller and strut or stern
tube:
(Photo #20). Contact manufacturer for special instructions. When a vessel
with an unusual arrangement is encountered, send drawings for factory
installation assistance. A zinc collar between propeller and cutter will act
as a filler in many cases.
          
 Marine Manufacturing
Inc.
201
SW 33rd Street Ft. Lauderdale, FL 33315 USA
E-mail: spurs@spursmarine.com
phone: (954) 463-2707
Fax: (954) 525-0239
spurs cutters are protected by USA and International patents
logo is a trademark of Spurs Marine Manufacturing Inc
Copyright ® All rights reserved.
|
