Line and Net Cutter Assembly

Above Parts blow out for series A-F cutters
See below for model F1,F2 and F3 parts blow out

1. Shaft Mounted Rotary Cutter
   (1A) Rotary Cutter with alignment lip
   (1B) Rotary Cutter without alignment lip
           note: casting machined together (must remain together/ not interchangeable)
2. Stainless Steel Socket Head Draw Cap Screw
   (2A) Draw down screw for rotary cutter lip side
   (2B) Draw down screw for rotary cutter clamping side 3/8 x 16 x 2" socket head cap screws
   (2C) two (2)  3/8 hex nuts with nylon
3. Stationary Cutter Ring
   (3A) with blade
   (3B) without blade
   (3C) model F & F1 = 1/4 x 20 x 5/8 ss socket head cap screw
           model F2  = 1/4 x 20 x 3/4 ss socket head cap screws
           model F3  = 1/4 x 20 x 7/8 ss socket head cap screws
4. Bearings 
    (4A) four (4) long-life anti-friction bearing (side-mounted / water-lubricated)
    (4B) bottom bearing tape (thoradon)
5. Holding Wedge Block (size depends on strut diameter and model cutter)
    (5A) three (3) 3/8 x 16 x (length varies depending on holding block used) ss socket head screws
    (5B) three (3) 3/8 ss hi-colar lock wash
6. Zinc Anode
  (6A)  10 x 32 x 5/8 ss Flat Head Socket Screw
7. Sound Dampening Plugs (pressed into stationary cutter ring w/ blade)