|
A. Scrape and clean shaft thoroughly (use emery tape). (photo
#1).
B. Use a dial caliper to determine where taper (if any) ends from
propeller hub. (Cutter cannot be mounted over taper.) MUST BE
CLAMPED ON STRAIGHT SHAFT. (Photo #2)
For acceptable installation refer to Diagrams A, B & C in
step 4.
C. Also check shaft size. Shaft should measure .002 (.050mm) over
nominal; metric or oriental shaft should be ordered to exact .001 (.025mm)
(Photo #2).
D. In preparation for installation - disassemble cutter: (1)
Loosen stationary blade screws only 1/2 way out (screws #4 on page 10).
(2) Remove screws on rotating cutters.
          
 Marine Manufacturing
Inc.
201
SW 33rd Street Ft. Lauderdale, FL 33315 USA
E-mail: spurs@spursmarine.com
phone: (954) 463-2707
Fax: (954) 525-0239
spurs cutters are protected by USA and International patents
logo is a trademark of Spurs Marine Manufacturing Inc
Copyright ® All rights reserved.
|
